Removing And Installing Fuel Gauge Sender 2 G169; Removing And Installing Fuel Gauge Sender 2 G169 ", Page - Skoda Octavia III 2013 Workshop Manual

– Disconnect plug connection -4- on the closing flange, thereby
unlocking the plug lock.
– Unhook the electric cable from the holder -arrow- and expose
it.
– Unlock catch on uptake clamps -1 and 2- and at the same time
pull the sender for fuel gauge display - G- -3- upwards.
Install
Installation is carried out in the reverse order. However, pay at‐
tention to the following:
– Insert the sender for fuel gauge display - G- in the guides at
the fuel delivery unit and press downwards until it latches into
position.
– Connect all electric cables to fuel delivery unit.
1.11 Removing and installing fuel gauge
sender 2 - G169-
For vehicles with four-wheel drive
Special tools and workshop equipment required
♦ Disassembly wedge - 3409-
♦ Key - T30101 (3087)-
Removing
•
The fuel tank must not be more than
Note
If necessary, extract fuel from the fuel tank
♦
Observe the safety instructions before starting fitting work
♦
⇒ page 2 .
Observe rules for cleanliness
♦
– Switch off ignition and all electrical loads, and pull out ignition
key.
– Removing rear seat bench ⇒ Body Work; Rep. gr. 72 .
– Unclip cover -1- for the left closing flange using the disassem‐
bly wedge - 3409- from the uptake -arrows-.
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
3
/ 4 full.
⇒ page 221
⇒ page 9 .
Octavia III 2013 ➤ , Octavia III 2014 ➤
.
241
1. Fuel tank