Removing And Installing Fan Shroud - Skoda Octavia III 2013 Workshop Manual

– Unlock the left and right catches from the cooler -1-
-arrow A- and raise the condenser.
– Press the radiator downwards until the radiator bearing de‐
flects at the bottom, to do so, unhook the condenser -2- from
the radiator -1-.
– Strap capacitor to the lock support.
– Remove the cooler for the charge air circuit from the vehicle
together with the cooler for coolant.
– Press left and right radiator locking lugs simultaneously
-arrow- and remove coolant radiator from the charge air circuit
radiator.
– Secure charge air cooler
Install
Installation is carried out in the reverse order. However, pay at‐
tention to the following:
Note
The radiator, capacitor and charge air cooler may have minor
♦
indentations on the fins, even if assembly is correct. This is not
a case of damage. Radiator, capacitors or charge air cooler
must not be replaced because of these indentations.
Replace O-rings after disassembly
♦
If the radiator has been replaced, all the entire coolant must
♦
be replaced.
– Install front bumper ⇒ Body Work; Rep. gr. 63 .
– Install fan shroud ⇒ page 215
– Replenish coolant ⇒ page 182
4.7

Removing and installing fan shroud

Removing
– Remove the sound dampening system ⇒ Body Work; Rep.
gr. 50 .
– Loosen hose clamps -1, 2- and remove air guide pipe.
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
.
.
Octavia III 2013 ➤ , Octavia III 2014 ➤
4. Radiator and radiator fan
215