Skoda Octavia III 2013 Workshop Manual page 54

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
Removing
– Remove the sound dampening system ⇒ Body Work; Rep.
gr. 50 .
– Remove the front right wheelhouse liner ⇒ Body Work; Rep.
gr. 66 .
WARNING
Risk of damage through reversing the rotation direction of an
already used V-ribbed belt.
♦ Mark the direction of rotation with chalk or a felt-tip pen
before removing the V-ribbed belt so that it can be rein‐
stalled after.
– Swivel tensioning device in -direction of arrow- in order to
slacken the V-ribbed belt.
– Secure tensioning device with locking pin - T10060 A- .
– Remove poly V-belt.
Install
Installation is carried out in the reverse order. However, pay at‐
tention to the following:
– Lay the poly V-belt as shown:
1 - Poly V-belt pulley
2 - Swivel tensioning pulley for V-ribbed belt
3 - Belt pulley for generator
4 - Belt pulley for AC compressor
– Turn the tensioning element in the -direction of the arrow- and
pull out the locking pin - T10060 A- .
– Release pressure on tensioning device.
– Check that the V-ribbed belt is positioned correctly.
– Start engine and check the right poly V-belt run.
46
Rep. gr.13 - Crankshaft group