Display Ntp-Service Sessions - Huawei Quidway S2000 Series Command Manual

Command Manual - System Management
Quidway S2000 Series Ethernet Switches
Description
Using debugging ntp-service command, you can debug different NTP services.
Using undo debugging ntp-service command, you can disable corresponding
debugging function.
By default, no debugging function is enabled.
Example
# Enable NTP access control debugging.
<Quidway> debugging ntp-service access

7.1.2 display ntp-service sessions

Syntax
display ntp-service sessions [ verbose ]
View
Any view
Parameter
verbose: Indicate to display the detail information about the sessions.
Description
Using display ntp-service sessions command, you can display the status of all the
sessions maintained by NTP service provided by the local equipment.
By default, the status of all the sessions maintained by NTP service provided by the
local equipment will be displayed.
When you configure this command without the verbose parameter, the Ethernet switch
will display the brief information about all the sessions it maintains.
With the verbose parameter configured, Ethernet switch will display the detail
information about all the sessions it maintains.
Example
<Quidway> display ntp-service sessions
source
********************************************************************
refid st now
7-2
Chapter 7 NTP Configuration Commands
poll reach delay offset disp