Brake Pipe - Subaru 2001 FORESTER Service Manual

Brake

17. Brake Pipe

A: REMOVAL
S405165A18
NOTE:
Airbag system wiring harness is routed near the
center brake pipe.
CAUTION:
¼ All Airbag system wiring harness and con-
nectors are colored yellow. Do not use electri-
cal test equipment on these circuits.
¼ Be careful not to damage Airbag system wir-
ing harness when servicing the center brake
pipe.
¼ When removing the brake pipe, make sure
that it is not bent.
B: INSTALLATION
NOTE:
Airbag system wiring harness is routed near the
center brake pipe.
CAUTION:
¼ All Airbag system wiring harness and con-
nectors are colored yellow. Do not use electri-
cal test equipment on these circuits.
¼ Be careful not to damage Airbag system wir-
ing harness when servicing the center brake
pipe.
¼ When installing the brake pipe, make sure
that it is not bent.
¼ After installing the brake pipe and hose,
bleed the air.
¼ After installing the brake hose, make sure
that it does not touch the tire or suspension
assembly, etc.
Brake pipe tightening torque:
15 N·m (1.5 kgf-m, 10.8 ft-lb)
BRAKE PIPE
S405165
S405165A11
C: INSPECTION
Ensure there are no cracks, breakage, or damage
on pipes. Check joints for fluid leakage. If any
cracks, breakage, damage or leakage is found,
repair or replace pipe.
NOTE:
Use a mirror when inspecting low-visible part or
back side.
BR-50
S405165A10