Brake Pipe - Subaru 2009 IMPREZA Service Manual

Hide thumbs Also See for 2009 IMPREZA:

16.Brake Pipe

The airbag system wiring harness is routed near

the center brake pipe.

• Airbag system wiring harness and connec-

tors are colored yellow. Do not use the electri-

cal test equipment on these circuits.

• Be careful not to damage the airbag system

wiring harness when servicing the center brake

• When removing the brake pipe, do not bend.

B: INSTALLATION

The airbag system wiring harness is routed near

the center brake pipe.

• Airbag system wiring harness and connec-

tors are colored yellow. Do not use the electri-

cal test equipment on these circuits.

• Be careful not to damage the airbag system

wiring harness when servicing the center brake

• When installing the brake pipe, do not bend.

• After installing the brake pipe and hose, per-

form air bleed.

• After installing the brake hoses, make sure

that they do not contact the tires or suspension

assembly, etc.

Brake pipe tightening torque:

Refer to "COMPONENT" of "General Descrip-

tion". <Ref. to BR-8, FRONT BRAKE PIPES

AND HOSES, COMPONENT, General De-

scription.> <Ref. to BR-9, CENTER AND

REAR BRAKE PIPES AND HOSES, COMPO-

NENT, General Description.>

C: INSPECTION

Make sure there are no cracks, breakage or dam-

age on hoses. Check the joint for fluid leakage. If

any cracks, breakage, damage or fluid leakage is

found, repair or replace the pipes.

Use a mirror when inspecting back sides and other

locations which are hard to see.