Table of Contents
Advertisement
®
ABB i-bus
KNX
Commissioning
6.2
Commissioning overview
The individual commissioning steps should be undertaken in the following recommended sequence:
1.
2.
3.
4.
5.
6.
Table 11: Commissioning overview
The parameters are downloaded to the device using the ETS function Download. See
Download
The device is then in operation and undertakes the functions parameterized. For information on the
operation of the web user interface, see
If you have any problems, see
40 2CDC508198D0211 Rev. A | AC/S 1.x.1
Commissioning steps
Installation of the ETS application
Installation of DCA
Configuration of the device addresses
• Physical KNX address
• IP configuration
• BACnet device address
Device firmware update check
Minimum parameterization of the device
• Set device clock
• Set users and passwords
• Set encrypted access to the web user
interface
Parameterization of the device
reaction.
chapter 10.4,
Remark
See
chapter 6.4, Software / application
See
chapter 6.4, Software / application
The configuration of the physical KNX address and
the IP configuration can also be undertaken without
DCA installed.
See
chapter 6.3, Assignment of the physical
address
See
chapter 6.3.1, Network settings
See
chapter 7.2.2.3, BACnet parameter page
Check whether an update is available for the device
software. In general an update will provide new
functions and rectify any bugs.
See
chapter 10.3, Software update
See
chapter 7.2.2.5, Clock parameter page
See
chapter 7.2.2.4, WebUI - Users parameter page
See
chapter 7.2.3.7, SSL certificate parameter page
For a description of the commissioning interface in
DCA, see
chapter 6.5, Device Configuration App
(DCA)
For a description of the application-specific
automation modules (ASM) as well as the general
device settings, see
For general notes and remarks, see
Planning and application
chapter 9.2, Web user
interface.
Support.
chapter 7
chapter 12,
chapter 6.5.11,
Advertisement
Table of Contents
