ABB i-bus KNX AC/S 1.x.1 Series Product Manual page 373

®
ABB i-bus KNX
Parameters
Custom supply temperature curve chart
If the supply setpoint temperature is calculated based on the weather, you can change the curve on the
web user interface by specifying the points. The points from the ASM settings parameterized are used as
the initial values.
The settings on the web user interface always apply. The parameters set in the ASM settings are
overwritten and only become active again on the reinstallation of the ASM.
AC/S 1.x.1 | 2CDC508198D0211 Rev. A 373