ABB i-bus KNX AC/S 1.x.1 Series Product Manual page 390

®
ABB i-bus KNX
Parameters
Object function
Input: Pump fault
The module has this group object if the Yes option is selected for the
The fault state of the pump can be received via this group object and evaluated by the device
Telegram value:
Input: Pump operating status (Off/On)
The module has this group object if the Yes option is selected for the
Input for the operating status (Off/On) provided by the pump. On pumps with their own control, this operating status can differ
from the operating status of the chiller.
Telegram value:
In-/Output: Pump override disable/enable Chiller
The module has this group object if the Yes option is selected for the
This object activates/deactivates the pump override for the chiller.
Telegram value:
In-/Output: Pump override value
The module has this group object if the Yes option is selected for the
This object specifies the state with which the pump for the chiller is overridden if the pump override is active.
Telegram value:
390 2CDC508198D0211 Rev. A | AC/S 1.x.1
Name (can be changed separately)
Chiller
0 = Inactive
1 = Active
Chiller
0 = Inactive
1 = Active
0 = Disabled
1 = Enabled
Chiller
0 = Off
1 = On
Data type
1 bit
DPT 1.011
Pump display pump fault status
1 bit
DPT 1.011
Pump display operating status parameter.
1 bit
DPT 1.003
Override by WebUI parameter.
1 bit
DPT 1.001
Override by WebUI parameter.
Flags
C, W, T
parameter.
C, W, T
C, R, W, T
C, R, W, T