ABB i-bus KNX AC/S 1.x.1 Series Product Manual page 386

®
ABB i-bus KNX
Parameters
Object name
Pump fault
The module has this output socket if the Yes option is selected for the
Outputs the fault status provided by the pump.
Signal value:
Pump repair switch status
The module has this output socket if the Yes option is selected for the
Outputs the contact position provided by the pump repair switch.
Signal value:
Pump override disable/enable
The module has this output socket if the Yes option is selected for the
Outputs whether the pump for the chiller is overridden.
Signal value:
Pump override value
The module has this output socket if the Yes option is selected for the
Outputs the state with which the pump for the chiller is overridden if the pump override is active.
Signal value:
386 2CDC508198D0211 Rev. A | AC/S 1.x.1
0 = No alarm
1 = Alarm
0 = Inactive
1 = Active
0 = Disabled
1 = Enabled
0 = Off
1 = On
Data type
DPT 1.005
Pump display pump fault status
DPT 1.011
Display pump repair switch status
DPT 1.003
Override by WebUI parameter.
DPT 1.001
Override by WebUI parameter.
parameter.
parameter.