Operating And Display Elements - ABB i-bus KNX AC/S 1.x.1 Series Product Manual

®
ABB i-bus KNX
Product Overview
3.4.3

Operating and display elements

Button/LED
Table 8: Operating and display elements
Device restart and factory reset are only possible if the bus voltage and supply voltage are applied.
A firmware update cannot be undone using the factory reset.
Description
Assignment of the physical KNX
address
ON
LAN/LINK
KNX telegram
Reset (behind label carrier)
Note
Note
LED indicator
On: Device is in KNX programming mode
Off: No supply voltage (24 V or PoE) available
On: System initialized
Flashing slowly (1 Hz): System starting up
Flashing quickly (4 Hz): Error
On: Supply voltage and Ethernet connection
available
Flickering: Data traffic via LAN
On: Supply voltage and KNX connection available
Flickering: Data traffic via LAN
Press for less than 2 seconds: no reaction.
Press for 2 to 10 seconds: device restart. Retains
configuration and last states.
Press for more than 10 seconds: factory reset.
Deletes configuration and all states.
AC/S 1.x.1 | 2CDC508198D0211 Rev. A 25