Table of Contents
Advertisement
®
ABB i-bus
KNX
Parameters
The following parameters are available for each BACnet object:
Enabled
Options:
Use this option to enable/disable the related BACnet object in the ASM.
Name
Options:
By default the name of the BACnet object is generated automatically from the ASM name and the object
name. If you select the Custom name checkbox you can specify any name you require.
The BACnet object name must be unique within the device. If the name you enter is already used by
another BACnet object in the device, DCA outputs an error message and does not allow the name to be
saved. In this situation the last name is restored.
ID
The number of the BACnet object is generated automatically by default.
You can change the BACnet object number. This number must be unique within the device. If the number
you select is already used by another BACnet object in the device, DCA outputs an error message and
does not allow the number to be saved. In this situation the last number is restored.
74 2CDC508198D0211 Rev. A | AC/S 1.x.1
No (checkbox cleared)
Yes (checkbox selected)
No (checkbox cleared)
Yes (checkbox selected)
Advertisement
Table of Contents
