ABB i-bus KNX AC/S 1.x.1 Series Product Manual page 461

®
ABB i-bus KNX
Parameters
Main data point type
Data point type
These two parameters select the data point type for the value recorded. The data point type for the ASM
input socket is set based on this settings and the unit displayed on the web user interface.
The following data point types can be selected:
•
1.xxx [1-bit]
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
•
5.xxx [8-bit unsigned]
o
o
o
o
o
o
•
6.xxx [8-bit signed]
o
o
o
1.*
1.001 [switch]
1.002 [boolean]
1.003 [enable]
1.004 [rise]
1.005 [alarm]
1.006 [binary value]
1.007 [step]
1.008 [up/down]
1.009 [open/close]
1.010 [start/stop]
1.011 [status]
1.012 [inversion]
1.013 [dimming send type]
1.014 [input type]
5.*
5.001 [percentage (0..100%]
5.003 [angle (degrees)]
5.004 [percentage (0..255)]
5.005 [ratio (0..255)]
5.010 [counter pulses (0..255)]
6.*
6.001 [percent (-128..127%(]
6.002 [counter pulses (-128..127)]
AC/S 1.x.1 | 2CDC508198D0211 Rev. A 461