Commissioning; Prerequisites For Commissioning; Commissioning Overview - ABB i-bus KNX Product Manual

®
ABB i-bus KNX

Commissioning

6 Commissioning
6.1

Prerequisites for commissioning

To commission the device, a PC with ETS is required along with a connection to the ABB i-bus
e.g. via a KNX interface.
The device is ready for operation after the bus voltage is applied.
6.2

Commissioning overview

The application Valve Drive Controller,4-f/...* is available for the valve drive controller VC/S 4.1.1.
The application Valve Drive Controller,
manual operation,4-f/...* is available for the valve drive controller VC/S 4.2.1.
ETS from version 4 is required to parameterize the device.
For information on how to use the i-bus
The available functions are as follows:
Function
Thermoelectric valve
Inputs (per channel)
Table 12: Commissioning functions
®
Tool, see 4.4
Valve drives are actuated. Control is via PWM or as an open/close signal for solenoid valves
There are 3 inputs available. These are used to monitor and/or connect, e.g., window
contacts, a condensation pan, dew point sensors or temperature sensors.
As an option, an analog room control unit can be connected to the first input on each channel
(a, d, g, j).
Integration in the i-bus® Tool
VC/S 4.x.1 | 2CDC508220D0211 Rev. A 35
®
,