Table of Contents
Advertisement
®
ABB i-bus
KNX
Parameters
Object name
Room: Floor heating, valve
Outputs the position of the floor heating valve.
The object type for the object is dependent on the settings in the module:
•
If the On/Off option is selected for the
Object type binary value
Unit –
Send condition –
Signal value 0 = Off, 1 = On
•
If the 0...100 % option is selected for the
Object type analog value
Unit % (98)
Send condition 1.0
Signal value 0...100 %
Room: Floor temperature sensor
The module has this BACnet output object if the On/Off option or the 0...100 % option is selected for the
parameter and the Yes option is selected for the Floor temperature sensor parameter.
Outputs the floor temperature.
Signal value:
Room: Cooling ceiling, valve
Outputs the position of the cooling ceiling valve.
The object type for the object is dependent on the settings in the module:
•
If the On/Off option is selected for the
Object type binary value
Unit –
Send condition –
Signal value 0 = Off, 1 = On
•
If the 0...100 % option is selected for the
Object type analog value
Unit % (98)
Send condition 1.0
Signal value 0...100 %
224 2CDC508198D0211 Rev. A | AC/S 1.x.1
Floor heating
Floor heating
-273...670760 °C
Cooling ceiling
Cooling ceiling
Object type
Binary value
Analog value
parameter:
parameter:
Analog value
Binary value
Analog value
parameter:
parameter:
Unit
COV send
condition
-
-
% (98)
1.0
°C (62)
1.0
Floor heating
-
-
% (98)
1.0
Advertisement
Table of Contents
