ABB i-bus KNX AC/S 1.x.1 Series Product Manual page 281

Application controller
Table of Contents

Advertisement

®
ABB i-bus
KNX
Parameters
Object name
Heating distribution circuit: Control On/Off override disable/enable
The module has this BACnet output object in the following conditions:
If the Yes option is selected for the
heating distribution circuit control based on ASM input socket
If the Yes option is selected for the
Outputs whether the control (Off/On) for the heating distribution circuit controller has been overridden via the web user
interface.
Signal value:
Heating distribution circuit: Room control values
The module has this BACnet output object in the following conditions:
If the Yes option is selected for the
selected for the
parameter.
If the Yes option is selected for the
Outputs the highest room setpoint temperature that is present on the ASM input socket and that is used by the Economy mode
and Switch off if no room demand functions.
Signal value:
Heating distribution circuit: Pump A override disable/enable
The module has this BACnet output object if the Yes option is selected for the
Outputs whether the heating distribution circuit's pump is overridden.
Signal value:
Heating distribution circuit: Pump A override value
The module has this BACnet output object if the Yes option is selected for the
This object specifies the state with which the heating distribution circuit's pump is overridden if the pump override is active.
Signal value:
Supply temperature control
Switch off if no room demand
0 = Not overridden
1 = Overridden
Supply temperature control
Supply setpoint temperature source
Switch off if no room demand
0...100 %
0 = Disabled
1 = Enabled
0 = Off
1 = On
Object type
Binary value
parameter and the Yes option is selected for the
parameter.
parameter.
Analog value
parameter, the Calculated weather compensated option is
parameter and the Yes option is selected for the
parameter.
Binary value
Override by WebUI
Binary value
Override by WebUI
AC/S 1.x.1 | 2CDC508198D0211 Rev. A 281
Unit
COV send
condition
-
-
Enable
% (98)
1.0
Room involvement
-
-
parameter.
-
-
parameter.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ac/s 1.2.1Ac/s 1.1.1

Table of Contents