ABB i-bus KNX AC/S 1.x.1 Series Product Manual page 124

®
ABB i-bus KNX
Parameters
RS Flip Flop (RS-FF)
Stores input states and resets them on request.
Inputs
No. DPT
1
2
Outputs
No. DPT
1
2
Parameters
Initial value:
Initial value of the input. Can only be used in combination with the Set initial value after restart parameter.
Selecting the checkbox sets the initial value to 1, but only with 1-bit values. Clearing the checkbox
(default) sets the initial value to 0.
Set initial value after restart:
The initial value is used after a restart.
After a restart, either the initial values are used or the input values are restored, or the system waits for a
telegram to arrive. In the first two cases, the logic function is not recalculated.
124 2CDC508198D0211 Rev. A | AC/S 1.x.1
Abbr.
1 bit S
1 bit R
Abbr. Name
1 bit A Output
1 bit IA Inverted output
Note
Note
Name Visible
Set Always
Reset Always
Visible
Always
Always
Description
A value of 1 sets the flip flop output to 1.
A value of 1 resets the flip flop output to 0
and disables it.
Description
Flip flop output status
Inverted flip flop output status