Undoing And Redoing - ABB i-bus KNX AC/S 1.x.1 Series Product Manual

®
ABB i-bus KNX
Commissioning
6.5.9

Undoing and redoing

You can undo individual changes made in ETS using the Undo button on the menu bar in DCA. Click
the
Use the Redo button on the menu bar in DCA to redo changes undone in ETS using the Undo button.
These two functions include every single change made in the ETS in chronological order. Here the
functions take into account every change in DCA on the application controller, and every general change
in the ETS project (group address, building structure, other KNX device parameters).
The Undo and Redo function in ETS can also undo and redo every change outside DCA individually.
However, it can only ever undo and redo changes within DCA back to when the DCA configuration was
saved. As such, it is not possible to select every individual step in DCA using the ETS Undo and Redo
function. We therefore recommend using the DCA Undo and Redo function.
54 2CDC508198D0211 Rev. A | AC/S 1.x.1
button to display the history for the recent changes; here you can select specific changes.