Software Update; Support - ABB i-bus KNX AC/S 1.x.1 Series Product Manual

®
ABB i-bus KNX
Operation
10.3

Software update

The device manufacturer may make available new device software on the manufacturer's web site. This
can contain bug fixes, performance improvements and new functions.
Please regularly check for new software versions.
You will find the current version number for DCA using the "About" button on the DCA menu bar, see
chapter 6.5.6, Menu
For further information on updating DCA, see ETS help.
You will find the current version of the device software (firmware) on the web user interface in "Device
information" on the menu bar (see
The device software is updated via the web user interface, see
parameter
and the IP configuration are retained. All values and states saved are lost. The configuration must be
programmed again by means of an ETS download.
You will find the current version of the ETS application program in ETS in the device properties. For further
information on updating the ETS application program, see ETS help.
10.4

Support

If you have problems with your device, support at the device manufacturer can use the following to analyze
the problem:
•
ETS log files. See ETS help.
•
Messages on the web user interface. See
•
Monitor mode for the Automation ASM. See
•
Accessing the device using SSH. See
•
Device log files. See
478 2CDC508198D0211 Rev. A | AC/S 1.x.1
bar.
chapter 9.2.1, Menu
page. The device configuration is deleted during the update. Only the physical KNX address
chapter 7.2.3.6, Log settings parameter
bar) or via the ETS function "Device information".
chapter 7.2.3.2, Firmware update
chapter 9.2.1, Menu bar.
chapter 7.2.3.4, Monitor mode parameter
chapter 7.2.3.5, SSH access parameter
page.
page.
page.