Table of Contents
Advertisement
®
ABB i-bus
KNX
Parameters
Object name
Room: Fan coil unit, fan manual
The module has this BACnet output object if any option except None is selected for the
Outputs whether the current fan speed has been adjusted manually by a user or it was calculated automatically by the room
thermostat.
Signal value:
Room: Fan coil unit, additional-stage heating
Outputs the status of the additional-stage heating
The object type for the object is dependent on the settings in the module:
•
If any option except None is selected for the
additional-stage heating
Object type binary value
Unit –
Send condition –
Signal value 0 = Off, 1 = On
•
If any option except None is selected for the
unit, additional-stage heating
Object type analog value
Unit % (98)
Send condition 1.0
Signal value 0...100 %
Room: Fan coil unit, fresh air damper
Outputs the position of the fresh air damper.
The object type for the object is dependent on the settings in the module:
•
If any option except None is selected for the
coil unit, fresh air damper
Object type binary value
Unit –
Send condition –
Signal value 0 = Closed, 1 = Open
•
If any option except None is selected for the
unit, fresh air damper
Object type analog value
Unit % (98)
Send condition 1.0
Signal value 0...100 %
222 2CDC508198D0211 Rev. A | AC/S 1.x.1
0 = Automatic
1 = Manual
Fan coil unit
parameter:
Fan coil unit
parameter:
Fan coil unit
parameter:
Fan coil unit
parameter:
Object type
Binary value
Fan coil unit
Binary value
Analog value
parameter and the On/Off option is selected for the
parameter and the 0...100 % option is selected for the
Binary value
Analog value
parameter and the Open/Closed option is selected for the
parameter and the 0...100 % option is selected for the
Unit
COV send
condition
-
-
parameter.
-
-
% (98)
1.0
Fan coil unit,
Fan coil
-
-
% (98)
1.0
Fan
Fan coil
Advertisement
Table of Contents
