Panasonic FP-E Programming Manual page 830

High−level Instructions
Flag conditions
・Error flag (R9007):
・Error flag (R9008):
How to specify S1
Specify the type of FP−e mode.
Value specified for S1
H0
H1
H2
H3
How to specify S2, S2+1, S2+2
With S2, S2+1 and S2+2 specify the display method of the screen specified with S1.
By writing the data below, the screen display method is specified in a 3−word range from the area specified
with S2.
For example, when DT10 is specified for S2, DT10 to DT12 becomes the area below.
S2: First word
Specifies the method in which all units are displayed.
15 12 11
Undefined (bits 15 to 10)
[Specify 0]
Lower display setting (bit 9)
[0: display, 1: no display]
Upper display setting (bit 8)
[0: display, 1: no display]
3 − 566
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Turns on and stays on when:
Turns on for an instant when:
− The area specified using the index modifier exceeds the limit.
− The value of S1 or S2 exceeds the limit of specified range.
Type of mode
N mode first screen
N mode second screen
S mode first screen
S mode second screen
8 7 4 3
Unit display setting (bits 7 to 0) [0: no display, 1: display]
− bit 0: Unit "PV"
− bit 1: Unit "SV"
− bit 2: Unit "s"
− bit 3: Unit "m"
− bit 4: Unit "h"
− bit 5: Unit " C"
− bit 6: Unit "F"
− bit 7: Unit " "
0
FP–e