Panasonic FP-E Programming Manual page 795

FPΣ/FP−X/FP0R
Flag conditions
・Error flag (R9007):
・Error flag (R9008):
Data table settings
S Control code
Duty
S+1
(*1): Control code specification (specify using K constant)
For FPΣ and FP−X
Resolution of 1000
Frequency Timing
K
(Hz) (ms)
K0 1.5
K1 2.0
K2 4.1
K3 6.1
K4 8.1
K5 9.8
K6 19.5
K7 48.8
K8 97.7
K9 201.6
K10 403.2
K11 500.0
K12 694.4
K13 1.0 k
K14 1.3 k
K15 1.6 k
K16 2.1 k
K17 3.1 k
K18 6.3 k
K19 12.5 k
Note: When using ch2 or ch3 on FP−X Tr type, use the control codes up to K20.
(*2): Specification of duty (specify using K constant)
If the control code is K0 to K19, the duty is K0 to K999 (0.0% to 99.9%).
If the control code is K20 to K24, the duty is K0 to K99 (0% to 99%).
Set values are specified in units of 1% (K10) (digits below the decimal point are rounded off).
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Turns on and stays on when:
Turns on for an instant when:
− The specified area is exceeded when an index is modified.
− The n is any value other than 0 or 2.
− The control code is outside specification range. (During instruction startup)
− The duty is higher than 100%. (During instruction startup)
− With the FP−X, the PWM output has not been set by the system register.
(*1)
(*2)
Resolution of 100
Frequency
K
(Hz)
666.67 K20 15.6 k
502.51 K21 20.8 k
245.70 K22 25.0 k
163.93 K23 31.3 k
122.85 K24 41.7 k
102.35
51.20
20.48
10.24
4.96
2.48
2.00
1.44
0.96
0.80
0.64
0.48
0.32
0.16
0.08
High−level Instructions
Timing
(ms)
0.06
0.05
0.04
0.03
0.02
3 − 531