Panasonic FP-E Programming Manual page 798

High−level Instructions
For FP−X Tr type
Channel no. Output
ch0 Y0
Y1
ch1 Y2
Y3
ch2 Y4
Y5
ch3 Y6
Y7
Note) There is no ch3 for C14T and C14TD.
Note) The pulse I/O cassette (AFPX−PLS) cannot be installed on the FP−X Tr type.
Note) Use the ch2 and ch3 at up to 20 kHz.
When the elapsed value of the high−speed counter reaches the target value specified in the data table, the
pulse frequency is switched (interrupt processing is carried out).
When the elapsed value agrees with the last target value, the pulse output operation finishes.
Use the F0 (MV) instruction to control the high−speed counter to force the pulse output control to stop.
If the frequency is set to 50 kHz or more, specify a duty of 1/4 (25%).
If the frequency for ch2 or ch3 of FP−X Tr type is set to 10kHz or more, specify a duty of 1/4 (25%).
Table of areas used
For FPΣ
Channel no. Control flag
ch0 R903A
ch2 R903C
For FP−X Ry type
Channel no. Control flag
ch0 R911C
ch1 R911D
For FP−X Tr type
Channel no. Control flag
ch0 ch0 R911C R911C
ch1 ch1 R911D R911D
ch2 ch2 R911E R911E
ch3 ch3 R911F R911F
Note) There is no ch3 for C14T and C14TD.
Note) The pulse I/O cassette (AFPX−PLS) cannot be installed on the FP−X Tr type.
Note) Use the ch2 and ch3 at up to 20 kHz.
3 − 534
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Output method
CW PLS
CCW SIGN
CW PLS
CCW SIGN
CW PLS
CCW SIGN
CW PLS
CCW SIGN
Elapsed value area Target value area
DT90044, DT90045 DT90046, DT90047
DT90200, DT90201 DT90202, DT90203
Elapsed value area Target value area
DT90348, DT90349 DT90350, DT90351
DT90352, DT90353 DT90354, DT90355
Elapsed value area Target value area
DT90348
DT90349
DT90352
DT90353
DT90356
DT90357
DT90360
DT90361
DT90350
DT90351
DT90354
DT90355
DT90358
DT90359
DT90362
DT90363
FPΣ/FP−X