Panasonic FP-E Programming Manual page 647

Specifying the relay station
2
S+1 should be used to specify only the specified amount of depth, while (S1+3) is used to specify
depth 2 for the same item, and (S1+4) is used to specify depth 3.
S1+2:
Specifying the remote station
3
This should be specified right after the specification of the relay station.
S1+n:
(n = depth + 2)
Example: When using the program example shown on page 3 − 376.
In this example, the data from DT100 to DT104 of the CPU (CPU5)
is received in DT50 to DT54 of the local station (CPU1) shown
below.
Connection diagram
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Route No. of relay destination in depth 1: H01 to H08
Unit No. of relay source in depth 1: H01 to H40 (1 to 64)
Specifies H00
Unit No. of remote station: H01 to H40(1 to 64)
1
No.2
1 2 3 4
No.16
DT50
to
DT54
DT100
to
DT104
1 2 3
1 2 3
No.4
No.10
High−level Instructions
3 − 383