Panasonic FP-E Programming Manual page 1108

Address
FP0 C10,
FP0 T32 C14, C16,
C32, SL1
DT9021
(Availabl
-
e type:
SL1)
DT90022 DT9022
Scan time display is only possible in RUN mode, and shows the operation cycle time. The maximum and
minimum values are cleared when each the mode is switched between RUN mode and PROG. mode.
5-20
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Name
No. of units connected
to S-LINK/error
address
Scan time (current
value)
(*Note)
Descriptions
(When normal)
Note
- When the SET switch is pressed, the number
of input/output units connected to the S-LINK
system is set.
(If the same address has been specified for
multiple units, the units are counted as a single
unit. This is invalid, however, if an ERR4 error is
in progress.)
(If ERR4 occurs)
The current scan time is stored here. Scan time
is calculated using the formula:
Scan time (ms) = stored data (decimal) x 0.1
K50 indicates 5 ms.