Table of Contents
Advertisement
Address
Scan time (current
DT90022
value)
Scan time (minimum
DT90023
value)
Scan time (maximum
DT90024
value)
Mask condition
monitoring register
DT90025
for interrupts
(INT0 to 11)
DT90026
Not used
Periodical interrupt
DT90027
interval (INT24)
DT90028
Sample trace interval
DT90029
Not used
DT90030
DT90031
DT90032
Character storage by
F149 MSG instruction
DT90033
DT90034
DT90035
DT90036
Not used
Note) Scan time display is only possible in RUN mode, and shows the operation cycle time. (In PROG.
mode, the scan time for the operation is not displayed.) The maximum and minimum values are
cleared each time the mode is switched from RUN to PROG.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Name
The current scan time is stored here. Scan
time is calculated using the formula:
Scan time (ms) = stored data (decimal) x 0.1
Note)
ms
Example: K50 indicates 5 ms.
The minimum scan time is stored here. Scan
time is calculated using the formula:
Scan time (ms) = stored data (decimal) x 0.1
Note)
ms
Example: K50 indicates 5 ms.
The maximum scan time is stored here. The
scan time is calculated using the formula:
Scan time (ms) = stored data (decimal) x 0.1
Note)
ms
Example: K125 indicates 12.5 ms.
The mask conditions of interrupts using the
instruction can be stored here. Monitor using
binary display.
-
The value set by ICTL instruction is stored.
K0: periodical interrupt is not used.
K1 to K3000: 0.5ms to 1.5s or 10ms to 30s
K0: Sampling by the SMPL instruction
K1 to K3000 (x 10 ms): 10 ms to 30 s
-
The contents of the specified message (Data
length) are stored in these special data
registers when F149 (MSG) instruction is
executed.
-
FP0R (A: Available, N/A: Not available)
Description
Read-
Writ-
ing
ing
A
N/A
A
N/A
A
N/A
A
N/A
N/A
N/A
A
N/A
A
N/A
N/A
N/A
A
N/A
N/A
N/A
5-61
Hide quick links:
Advertisement
Table of Contents
