Panasonic FP-E Programming Manual page 1291

Name Boolean
UP/DOWN F118
counter (UDC)
Shift SR
register
Left/right F119
shift (LRSR)
register
Control instructions
Master MC
control
relay
Master MCE
control
relay end
Jump JP
Label
LBL
Auxiliary F19
jump (SJP)
Label LBL
Loop LOOP
LBL
Label
Break BRK
: Available, : Not available,
*1) In the FP2/FP2SH/FP10SH, when internal relay WR240 or higher is used, the number of steps is the number in
parentheses. Also, in the FP2/FP2SH/FP10SH, when the specified internal relay number (word address has an index
modfier, the number of steps is the number in parentheses.
*2) In the FP2/FP2SH/FP10SH, when the number "n" in a jump instruction has an index modifier, the number of steps
isthenumber in parentheses.
*3) In the FP2/FP2SH/FP10SH, when the number "n" in a loop instruction has an index modifier, the number of steps is the
number in parentheses.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Symbol
Increments or decrements from the
preset value "S" based on up/donw
input.
Shifts one bit of 16-bit [word internal
relay (WR)] data to the left.
Shifts one bit of 16-bit data range
specified by "D1" and "D2" to the left or
to the right.
Starts the master control program.
Ends the master control program.
The program jumps to the label
instruction and continues from there.
The program jumps to the label
instruction specified by "S" and
continues from there.
The program jumps to the label
instruction and continues from there (the
number of jumps is set in "S").
Stops program execution when the
predetermined trigger turns on in the
TEST/RUN mode only.
: Not available partially
Description
5
1
(2)
*1
5
2
2
2
(3)
*2
1
3
1
4
(5)
*3
1
1
5-203