Table of Contents
Advertisement
5
F355
(PID)
Outline
This instruction carries out PID processing using data table.
Program example
Trigger
R0
10
F355 PID, DT 10
S
Operands
Relay
Operand
Operand
WX WY WR WL
S
N/A N/A N/A N/A
Description
PID processing is performed to hold the measured value specified by S+2 at the set value S+1, and the result
is output to S+3.
Derivative control or proportional−derivative control can be selected for the PID processing mode.
Set the PID processing coefficients (proportional gain, integral time and derivative time) and the processing
mode and cycle in the parameter table. PID processing will be performed based on these settings.
Types of PID processing
Reverse operation and forward operation
When a process has been changed, the vertical direction of the output can be selected.
If the measured value drops, "Reverse operation" is specified to boost the output (heating, etc.).
If the measured value increases, "Forward operation" is specified to boost the output (cooling, etc.).
Derivative type (PI−D) / Proportional−derivative type (I−PD)
Generally, with "derivative PID control", when a set value is changed, there is increased fluctuation in the
output, but convergence is faster.
Generally, with "proportional−derivative PID control", when a set value is changed, there is less fluctuation in
the output, but convergence is slower.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
PID processing
Ladder Diagram
Ladder Diagram
S
Starting number of PID parameter area (30 words)
Timer/Counter Register
SV
EV
DT
N/A
N/A
A
High−level Instructions
Address
10
11
Index
Constant
register
I
K
H
f
N/A
N/A
N/A
N/A
Boolean
Instruction
ST
R
0
F355
(PID)
DT
10
Index
modifier
modifier
N/A
A:
Available
N/A: Not Available
next page
3 − 761
Hide quick links:
Advertisement
Table of Contents
