Panasonic FP-E Programming Manual page 1105

FP0
Address
R9029
Forcing flag
(*Note)
R902A External interrupt
(*Note) enable flag
R902B
Interrupt error flag
(*Note)
R902C to
Not used
R902F
R9030,
Not used
R9031
RS232C port mode
R9032
flag
Printout instruction
R9033
flag
Rewrite during RUN
R9034
flag
S-LINK I/O communi-
R9035
cation error flag
S-LINK communica-
R9036
tion status flag
RS232C communica-
R9037
tion error flag
RS232C reception
R9038
completed flag
RS232C transmission
R9039
completed flag
High-speed
R903A counter control
flag
High-speed
R903B counter control
flag
High-speed
R903C counter control
flag
High-speed
R903D counter control
flag
R903E,
Not used
R903F
Note) Used by the system.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Name
Turns on during forced on/off operation for input/output relay
timer/counter contacts.
Turns on while the external interrupt trigger is enabled by
the ICTL instruction.
Turns on when an interrupt error occurs.
-
-
When "General-use port" is selected, "K2" goes on.
Turns on while a F147 (PR) instruction is executed.
Turns off when a F147 (PR) instruction is not executed.
This is a special internal relay that goes on for only the first
scan following the completion of rewriting in the RUN mode.
(CPU Ver. 2.1 or later available)
Turns on when the S-LINK error (ERR 1, 3 or 4) occurs
using S-LINK system.
Turns on when communication is taking place with an S-
LINK input/Ooutput unit.
Turns on when the serial data communication error occurs.
Turns on when a terminator is received during the serial
data communicating.
Turns on while data is not send during the serial data
communicating.
Turns off while data is being sent during the serial data
communicating.
Turns on while the high-speed counter instructions
ch0
F166(HC1S) to F170(PWM) are executed.
Turns on while the high-speed counter instructions
ch1
F166(HC1S) to F170(PWM) are executed.
Turns on while the high-speed counter instructions
ch2
F166(HC1S) to F170(PWM) are executed.
Turns on while the high-speed counter instructions
ch3
F166(HC1S) to F170(PWM) are executed.
-
Description
5-17