Panasonic FP-E Programming Manual page 1094

2. Hold types and non-hold type settings (System registers 6 to 8 and 14)
With the C10/C14/C16/C32/SL1, the areas held in the event of a power supply interruption are fixed at
the areas shown in the table below, and the settings for system registers 6 to 8 and 14, will be invalid.
C10/C14/C16
Timer Non-hold type: All points
Non-hold type: From the set value to C139
Counter
Hold type: 4 points (elapsed values )C140 to C143
Non-hold type:
Internal relay
Hold type:
Non-hold type: 1652 words (DT0 to DT1651)
Data register
Hold type: 8 words (DT1652 to DT1659)
C32/SL1
Timer Non-hold type: All points
Non-hold type: From the set value to C127
Counter
Hold type: 16 points (elapsed values )C128 to C143
Non-hold type:
Internal relay
Hold type:
Non-hold type: 6112 words (DT0 to DT6111)
Data register
Hold type: 32 words (DT6112 to DT6143)
With the T32, set each relay and register to a hold type or non-hold type.
For normal situations, set the system registers 5 and 6 to the same value. This sets the timer to a non-
hold type and counter to a hold type.
By setting this value to "0", the whole area becomes hold type. Also, by setting it to the valeu 1 higher
than the last number, the whold area becomes non-hold type.
C32/SL1
Type
Area
Timer
Counter
Internal Non-hold type
relay
Hold type
Data register
5-6
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
976 points (R0 to R60F)
61 words (WR0 to WR60)
32 points (R610 to R62F)
2 words (WR61 to WR62)
880 points (R0 to R54F)
55 words (WR0 to WR54
128 points (R550 to R62F)
8 words (WR55 to WR62)
All non-hold type
All hold type
Non-hold type: 10 words (WR0 to WR9)
Hold type: 53 words (WR10 to WR62)
All hold type
T32