Panasonic FP-E Programming Manual page 1056

Precautions Concerning Programs
Operation and cautions after the change
After the change using the programming tool software or FP programmer II, the timer
or counter in operation will continue to run. Operation based on the changed set value
will be start the next time the execution condition changes from off to on.
If changing values using the boolean (ladder/non−ladder) mode input method available
in the programming tool software, subtraction is interrupted when the values are
rewritten, and starts again with the new value, starting from the next scan.
When method of constant rewriting in the program is used, the program itself will
change. Thus, when the mode is changed and then set back to RUN or when the power
is turned on, the changed set value will be preset.
4 - 4
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com