Panasonic FP-E Programming Manual page 1153

Address
Clock/calender setting
and 30 seconds
DT90058
correction register
(T32 only)
Communication error
DT90059
code
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Name
The clock/calender is adjusted as follows.
When setting the clock/calender by
program
By setting the highest bit of DT90058 to 1, the
time becomes that written to DT90054 to
DT90057 by F0 (MV) instruction. After the
time is set, DT90058 is cleared to 0. (Cannot
be performed with any instruction other than
F0 (MV) instruction.)
<Example>
Set the time to 12:00:00 on the 5th day when
the X0 turns on.
Note) If the values of DT90054 to DT90057
are changed with the programming tool
software, the time will be set when the new
values are written. Therefore, it is
unnecessary to write to DT90058.
When the correcting times less than 30
seconds
By setting the lowest bit of DT90058 to 1, the
value will be moved up or down and become
exactly 0 seconds. After the correction is
completed, DT90058 is cleared to 0.
Example:
Correct to 0 seconds with X0: on
At the time of coorection, if between 0 and 29
seconds, it will be moved down, and if
between 30 and 59 seconds, it will be moved
up.
In the example above, if the time was 5
minutes 29 seconds, it will become 5 minutes
0 seconds;and, if the time was 5 minutes 35
seconds, it will become 6 minutes 0 seconds.
Error code is sotred here when a
communication error occurs.
FP0R (A: Available, N/A: Not available)
Description
Read- Writ-
ing ing
A A
N/A N/A
5-65