Panasonic FP-E Programming Manual page 1266

FP2/FP2SH/FP3/FP10SH (A: Available, N/A: Not available)
Address
FP2/
FP3 FP2SH
FP10SH
DT9018 DT90018
DT9019 DT90019
DT9020 -
- DT90020
DT9021
-
(*Note)
DT90021
-
(*Note)
Note) Used by the system.
5-178
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Name
The address whre an operation error
occurred is stored. Each time an error
Operation error occurs, the new address overwrites the
address previous address. At the beginning of
(non-hold) scan, the addressis 0. Monitor the
address using decimal display.
(Reference: DT90258)
The data stored here is increased by one
very 2.5 ms (H0 to HFFFF)
2.5 ms ring
Difference between the values of the two
counter
points (absolute value) x 2.5 ms =
Elapsed time between the two points.
Maximu value of
program The last address of sequence program
(Available PLC: area set in system register 0 is stored.
FP3)
The program capacity is stored in
Display of
decimal.
program
Example:
capacity
K30: approx. 30 K steps
(Available PLC:
K60: approx. 60 K steps (with memory
FP10SH)
expansion)
The program capacity is stored in
Display of
decimal.
program
Example:
capacity
K16: approx. 16 K steps (K15870)
(Available PLC:
K32: approx. 32 K steps (with memory
FP2)
expansion)
Maximum value
of file register The maximum (last) address of the file
(Available PLC: registers available are stored in here.
FP3)
Maximum value
of file register The maximum (last) address of the file
(Available PLC: registers available are stored in here.
FP2/FP10SH)
Descriptions
Read- Writ-
ing ing
A N/A
N/A N/A