Panasonic FP-E Programming Manual page 663

Explanation of example
Five words of data stored in data registers DT10 to DT14 of CPU are written into the addresses starting from
K0 to K4 of the intelligent unit shared memory (located in slot 0) when trigger R10 turns on.
0 1 2 3 4
CPU
DT0
DT1
DT10
DT11
DT12
DT13
DT14
Description
Writes n words of the initial data from the area specified by S2 of the CPU to the address specified by D of the
shared memory of the intelligent unit specified by S1.
Specifying the various items
Specifying the slot number and bank number (S1)
Specify the slot in which the intelligent unit has been installed. If the memory has a bank, enter a specification
that matches the bank number.
Number of words to be written (n)
Specify this using a K constant.
To write 10 words of data, specify "K10".
Initial address written to the shared memory of the intelligent unit (D)
Specify this referring to the table of shared memories for the various intelligent units.
To specify address 2, specify "K2".
Flag conditions
・Error flag (R9007):
・Error flag (R9008):
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
(Slot No.)
Intelligent unit
0
1
2
3
4
5
6
Turns on and stays on when:
Turns on for an instant when:
− The value of S1 exceeds the limit of specified range.
− The area specified using the index modifier exceeds the limit.
− The range of writing data exceeds the area specified using S2.
5 words
High−level Instructions
3 − 399