Panasonic FP-E Programming Manual page 641

Example of bit unit reception
2
When the control data is as follows:
DT10(S1)=H850D
Bit unit
DT11(S1+1)=H010A
the on and off information of Bit No. 13 of DT100 of the unit No. 10 connected to route No. 1 is sent
to Bit No. 5 of DT50 when the execution condition (trigger) R0 turns on.
Description
This reads the data in the area specified by S2 and N of a remote station connection with the MEWNET−W,
MEWNET−P, MEWNET−H, and stores it in the area specified by D of the local station.
The remote stations (routes and unit numbers), the transmission unit (bit unit or word unit), the transmission
method, and other parameters are specified by the control data S1.
(Receiving request)
D
Link
Local
unit
station
CPU
The remote station is specified by S1.
If general−purpose communication through the COM. port of the FP2, FP2SH, and FP10SH is being used,
F144 (TRNS) instruction is used instead of this instruction.
Refer to the section describing the F144 (TRNS) instruction.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Bit No. 13 of remote station's memory area
Bit No. 5 of local station's memory area
Unit No.10
Route No.1
S2 N
Data
Remote
station
High−level Instructions
3 − 377