Panasonic FP-E Programming Manual page 1183

(A: Available, N/A: Not available)
Register
No.
Scan time (current
DT90022
value)
Scan time (minimum
DT90023
value)
Scan time (maximum
DT90024
value)
Mask condition
monitoring register
DT90025
for interrupts
(INT0 to 7)
DT90026 Not used
Periodical interrupt
DT90027
interval (INT24)
DT90028 Not used
DT90029 Not used
DT90030 Message 0
DT90031 Message 1
DT90032 Message 2
DT90033 Message 3
DT90034 Message 4
DT90035 Message 5
DT90036 Not used
Note) Scan time display is only possible in RUN mode, and shows the operation cycle time. (In PROG.
mode, the scan time for the operation is not displayed.) The maximum and minimum values are
cleared earh time the mode is switched from RUN to PROG.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Name
The current scan time is stored here. Scan
time is calculated using the formula:
Scan time (ms) = stored data (decimal) x 0.1
Note)
ms
Example: K50 indicates 5 ms.
The minimum scan time is stored here. Scan
time is calculated using the formula:
Scan time (ms) = stored data (decimal) x 0.1
Note)
ms
Example: K50 indicates 5 ms.
The maximum scan time is stored here. The
scan time is calculated using the formula:
Scan time (ms) = stored data (decimal) x 0.1
Note)
ms
Example: K125 indicates 12.5 ms.
The mask conditions of interrupts using the
instruction can be stored here. Monitor using
binary display.
The value set by ICTL instruction is stored.
K0: periodical interrupt is not used.
K1 to K3000: 0.5ms to 1.5s or 10ms to 30s
The contents of the specified message (Data
lenght) are stored in these special data
registers when F149 (MSG) instruction is
executed.
Descriptions
Read Writ-
-ing ing
A N/A
A N/A
A N/A
A N/A
N/A N/A
A N/A
N/A N/A
N/A N/A
A N/A
N/A N/A
5-95