Port, Vlan, And Flow Mirroring On Acx5000 Series Routers - Juniper ACX1000 Configuration Manual

ACX Series Universal Access Router Configuration Guide
Related
Documentation

Port, VLAN, and Flow Mirroring on ACX5000 Series Routers

1386
and family
ethernet-switching
, then output must also be family
ethernet-switching
inet , then the output must also be family
configure flow-based mirroring without any firewall filter match conditions, then
mirroring is based on logical interface. The ACX5000 line of routers do not support
IPv6, CCC, MPLS, and VPLS family options under the [
port-mirroring ] hierarchy level.
NOTE:
In flow-based mirroring, firewall filters can be configured on a logical
interface as well as on a physical interface.
If the option for a VLAN (bridge domain) is not configured, or if the
vlan-id
option is configured as none, then the mirrored packet is sent as is
vlan-id
without any additional VLAN tags.
VLAN and Flow Mirroring on ACX5000 Series Routers on page 1386
Configuring VLAN Mirroring on ACX5000 Series Routers
Configuring Flow Mirroring on ACX5000 Series Routers
show forwarding-options analyzer
show forwarding-options port-mirroring
The ACX5000 line of routers supports port, VLAN, and flow mirroring modes to mirror a
copy of a packet from a source port to a destination port.
The ACX5000 line of routers supports the following mirroring modes:
Port mirroring—In this mode, packets entering to a configured port are mirrored. You
need to include the
analyzer
level, where input to a mirror is through a list of ports configured through the logical
interface
VLAN mirroring—In this mode, packets entering a VLAN (based on bridge domain) are
mirrored. You need to include the
hierarchy level, where input to a mirror is a VLAN (based on bridge domain).
Flow mirroring—In this mode, input parameters for mirroring are specified through a
firewall filter. You need to include the
forwarding-options ] hierarchy level. The ACX5000 line of routers supports only family
and family
ethernet-switching
, then output must also be family
ethernet-switching
inet , then the output must also be family
configure flow-based mirroring without any firewall filter match conditions, then
mirroring is based on logical interface. The ACX5000 line of routers do not support
configurations. If the input is family
inet
ethernet-switching
inet with output option as IP address. If you
edit forwarding-options
CLI statement at the [
edit forwarding-options
analyzer CLI statement at the [
CLI statement at the [
port-mirror
configurations. If the input is family
inet
ethernet-switching
inet with output option as IP address. If you
Copyright © 2017, Juniper Networks, Inc.
. If input is family
] hierarchy
edit forwarding-options ]
edit
. If input is family