Example: Configuring Policing On An Atm Ima Pseudowire - Juniper ACX1000 Configuration Manual

Related
Documentation

Example: Configuring Policing on an ATM IMA Pseudowire

Requirements
Copyright © 2017, Juniper Networks, Inc.
Specify the ATM interface unit:
3.
[edit interfaces at-fpc/pic/port]
user@host# edit unit logical-unit-number
Apply the ATM policer:
4.
[edit interfaces at-fpc/pic/port unit logical-unit-number]
user@host# set atm-policer input-atm-policer policer-name
Specify the encapsulation family type:
5.
[edit interfaces at-fpc/pic/port unit logical-unit-number]
user@host# set family ccc
After you have configured the ATM IMA interface, enter the
configuration mode.
Understanding CoS on ATM IMA Pseudowire Interfaces Overview on page 895
Example: Configuring Policing on an ATM IMA Pseudowire on page 915
Configuring Fixed Classification on an ATM IMA Pseudowire on page 897
Configuring Shaping on an ATM IMA Pseudowire on page 901
This example shows the configuration of policing on an ATM IMA pseudowire. On ACX
Series routers, the ATM policer is an input policer that is applied to the ATM IMA logical
interface. The ATM IMA logical interface must have the circuit cross-connect (CCC)
encapsulation family configured for the configuration to work.
NOTE: This example is not applicable on ACX5048 and ACX5096 routers.
Requirements on page 915
Overview on page 916
Configuration on page 916
This example uses the following hardware and software components:
ACX Series router
Junos OS Release 12.2 or later
A previously configured ATM IMA pseudowire. For steps to configure an ATM IMA
pseudowire, see "Configuring Inverse Multiplexing for ATM (IMA)" on page
Chapter 27: Configuring Class of Service
command in
commit
185.
915