Juniper ACX1000 Configuration Manual page 1124

ACX Series Universal Access Router Configuration Guide
Table 77: Nonterminating Actions for Standard Firewall Filters on ACX Series
Routers (continued)
Nonterminating Action
loss-priority (high | medium-high | low)
policer policer-name
1066
Description
Set the packet loss priority
(PLP) level.
You cannot also configure the
three-color-policer
nonterminating action for the
same firewall filter term. These
two nonterminating actions
are mutually exclusive.
You must include the
tri-color
statement at the
[edit
hierarchy
class-of-service]
level to commit a PLP
configuration with any of the
four levels specified. If the
statement is not
tri-color
enabled, you can configure
only the and levels.
high low
This applies to all protocol
families.
For information about the
statement, see
tri-color
Configuring and Applying
Tricolor Marking Policers. For
information about using
behavior aggregate (BA)
classifiers to set the PLP level
of incoming packets, see
Understanding How Forwarding
Classes Assign Classes to
Output Queues.
NOTE: This action is
supported on ingress only.
Name of policer to use to
rate-limit traffic.
Protocol Families
family any
family inet
family inet6
family mpls
family ccc
family bridge
family vpls
family any
family inet
family inet6
family mpls
family ccc
family bridge
family vpls
Copyright © 2017, Juniper Networks, Inc.