Juniper ACX1000 Configuration Manual page 1374

ACX Series Universal Access Router Configuration Guide
Step-by-Step
Procedure
1316
[edit protocols l2circuit neighbor 10.255.14.225 interface ge-2/0/5.601]
user@PE1# set virtual-circuit-id 601
user@PE1# set encapsulation-type ethernet-vlan
user@PE1# set backup-neighbor
Configure the router ID.
5.
[edit routing-options]
user@PE1# set router-id 10.255.14.217
The following example requires you to navigate various levels in the configuration
hierarchy. For information about navigating the CLI, see Using the CLI Editor in Configuration
Mode in the CLI User Guide.
To configure H-VPLS on the MTU device:
Configure the interfaces.
1.
On the PE-r device interface that connects to the customer edge, configure one of
the VPLS encapsulation types and the VPLS address family. This enables VPLS.
On the core-facing interfaces, enable MPLS labels. The ISO address is needed as
well on the core-facing interfaces because IS-IS is used in the core.
[edit interfaces]
user@PE2# set ge-2/0/6 vlan-tagging
user@PE2# set ge-2/0/6 encapsulation vlan-vpls
user@PE2# set ge-2/0/6 unit 601 encapsulation vlan-vpls
user@PE2# set ge-2/0/6 unit 601 vlan-id 601
user@PE2# set ge-2/0/6 unit 601 family vpls
user@PE2# set ge-2/0/10 unit 0 family inet address 192.0.2.4/24
user@PE2# set ge-2/0/10 unit 0 family iso
user@PE2# set ge-2/0/10 unit 0 family mpls
user@PE2# set lo0 unit 0 family inet address 10.255.14.216/32
user@PE2# set lo0 unit 0 family iso address 49.0001.0102.5501.4216.00
Enable MPLS and LDP on the interfaces.
2.
On the MTU device interfaces that connect to other PE devices, configure MPLS
and LDP.
[edit protocols mpls]
user@PE2# set interface ge-2/0/10.0
[edit protocols ldp ]
user@PE2# set interface ge-2/0/10.0
user@PE2# set interface lo0.0
Enable routing on the interfaces.
3.
10.255.14.216 standby
Copyright © 2017, Juniper Networks, Inc.