Pseudowire - Juniper ACX1000 Configuration Manual

ACX Series Universal Access Router Configuration Guide
Configuration
CLI Quick
Configuration
Configuring
Benchmarking Test
Parameters on Router
A
1368
of PE1. An MPLS tunnel connects PE1 and PE2 over the Ethernet pseudowire or the
Ethernet line (E-LINE).
This benchmarking test is used to compute the performance attributes in the
network-to-network interface (NNI) direction of an Ethernet pseudowire service between
Router A and Router B. The logical interface under test on Router A is the CE1 interface
with UNI as the direction, and the logical interface under test on Router B is the CE2
interface with NNI as the direction. Data traffic arriving from UNI towards NNI is ignored
while the test is in progress. Packets from NNI are not sent toward the customer edge
because all packets are assumed to be test frames. The CCC family and NNI direction
are configured on routers A and B.
Figure 72 on page 1368 shows the sample topology to perform an RFC 2544 test for the
NNI direction of an Ethernet pseudowire service.
Figure 72: RFC 2544-Based Benchmarking Test for NNI Direction of an
Ethernet Pseudowire
In this example, you configure the benchmarking test for the NNI direction of an Ethernet
pseudowire service that is enabled between two routers to detect and analyze the
performance of the interconnecting routers.
Configuring Benchmarking Test Parameters on Router B on page 1369
Configuring Benchmarking Test Parameters on Router B on page 1372
Results on page 1373
To quickly configure this example, copy the following commands, paste them in a text
file, remove any line breaks, change any details necessary to match your network
configuration, and then copy and paste the commands into the CLI at the [
level:
edit ] hierarchy
Copyright © 2017, Juniper Networks, Inc.