Configuring A Vpls Policer - Juniper ACX1000 Configuration Manual

Configuring a VPLS Policer

Copyright © 2017, Juniper Networks, Inc.
output output-filter-name;
}
You can include this statement at the following hierarchy levels:
[edit interfaces interface-name unit number family vpls]
[edit logical-systems logical-system-name interfaces interface-name unit number
family vpls]
NOTE: ACX Series routers do not support the
In the statement, list the name of the VPLS filter to be evaluated when packets are
input
received on the interface. In the
evaluated when packets are transmitted on the interface.
For the statement summaries for these statements, see the Junos OS Network Interfaces
Library for Routing Devices.
You can configure a policer for VPLS traffic. The VPLS policer configuration is similar to
the configuration of any other type of policer.
When specifying policing bandwidth, the VPLS policer considers all Layer 2 bytes in a
packet to determine the packet length.
To configure a VPLS policer, include the
level:
[edit firewall]
policer policer-name {
bandwidth-limit limit;
burst-size-limit limit;
then action;
}
For the statement summaries of these statements and more information about how to
configure policers, see the Routing Policies, Firewall Filters, and Traffic Policers Feature
Guide.
To apply a VPLS policer to an interface, include the
policer {
input input-policer-name;
output output-policer-name;
}
You can include this statement at the following hierarchy levels:
[edit interfaces interface-name unit number family vpls]
[edit logical-systems logical-system-name interfaces interface-name unit number
family vpls
Chapter 35: Configuring Virtual Private LAN Service
[edit logical-systems]
statement, list the name of the VPLS filter to be
output
policer statement at the
policer
hierarchy.
[edit firewall] hierarchy
statement:
1273