Juniper ACX1000 Configuration Manual page 1856

ACX Series Universal Access Router Configuration Guide
Required Privilege
Level
Related
Documentation
List of Sample Output
Output Fields
Table 112: monitor ethernet synthetic-loss-measurement Output Fields
Output Field Name
ETH-SLM request to
Interface
SLM packets sent
SLR packets received
Local TXFC1 value
Local RXFC1 value
Last Received SLR frame
TXFCf(tc)
Last Received SLR frame
TXFCb(t
Frame loss (near-end)
Frame loss (far-end)
1798
trace and maintenance
clear oam ethernet connectivity-fault-management synthetic-loss-measurement
on page 1788
monitor ethernet synthetic-loss-measurement on page 1796
show oam ethernet connectivity-fault-management loss-statistics
monitor ethernet synthetic-loss-measurement on page 1799
The
monitor ethernet synthetic-loss-measurement
at the CLI, depending on when you start a synthetic frame loss measurement:
Table 112 on page 1798 lists the run-time output fields for the
synthetic-loss-measurement
Output fields are listed in the approximate order in which they appear.
Output Field Description
Unicast MAC address of the remote peer MEP.
Name of the Ethernet physical, logical, or trunk interface to which the local MEP is attached.
Total number of synthetic loss message (SLM) PDU frames sent from the source MEP to the
remote MEP during this ETH-SLM session.
Total number of synthetic loss reply (SLR) PDU frames received by the source MEP from the
remote MEP during this measurement session.
Number of synthetic frames transmitted to the peer MEP for a test ID. A test ID is used to distinguish
each synthetic loss measurement because multiple measurements can be simultaneously activated
also on a given CoS and MEP pair. It must be unique at least within the context of any SLM for the
MEG and initiating MEP.
Number of synthetic frames received from the peer MEP for a test ID. The MEP generates a unique
test ID for the session, adds the source MEP ID, and initializes the local counters for the session
before SLM initiation. For each SLM PDU transmitted for the session (test ID), the local counter
TXFC1 is sent in the packet.
Value of the local counter TxFCl at the time of SLM frame transmission.
Value of the local counter RxFCl at the time of SLR frame transmission.
Count of frame loss associated with ingress data frames.
Count of frame loss associated with egress data frames.
command displays different output
command.
Copyright © 2017, Juniper Networks, Inc.
monitor ethernet