Juniper ACX1000 Configuration Manual page 1261

Table 95: jnxSoamDmCfgTable (continued)
Object
jnxSoamDmCfgDestIsMepId
jnxSoamDmCfgStartTimeType
Copyright © 2017, Juniper Networks, Inc.
Chapter 34: Configuring Operations, Administration, and Management (OAM)
Object ID
jnxSoamDmCfgEntry 14
jnxSoamDmCfgEntry 15
Description
Specifies whether the MEP ID or the MAC
address of the destination MEP is used for
SOAM DM frame transmission.
A value of 'true' indicates that MEPID of the
target MEP is used for SOAM DM frame
transmission. A value of 'false' indicates that
the MAC address of the target MEP is used
for SOAM DM frame transmission.
This object is only valid for the entity
transmitting the Delay Measurement frames,
types 'dmDmm' and 'dm1DmTx'. It is not
applicable for the 'dm1DmRx type.
This object can only be written at row
creation time and cannot be modified once
it has been created.
Specifies the type of start time of the SOAM
DM session. The start time can be disabled
(none), immediate, relative, or fixed.
The value of 'none' is illegal and a write error
will be returned if this value is used.
The value of 'immediate' starts the SOAM
DM session when the
jnxSoamDmCfgEnabled is true.
The value of 'fixed' starts the SOAM DM
session when the
jnxSoamDmFixedStartDateAndTime is less
than or equal to the current system date and
time and jnxSoamDmCfgEnabled is true.
This value is used to implement an
On-Demand fixed time PM session.
The value of 'relative' starts the SOAM DM
session when the current system date and
time minus the
jnxSoamDmRelativeStartTime is greater
than or equal to the system date and time
when the jnxSoamDmStartTimeType object
was written and jnxSoamDmCfgEnabled is
true. This value is used to implement an
On-Demand relative time PM session.
This object can only be written at row
creation time and cannot be modified once
it has been created.
1203