Configuring A Test Profile For An Rfc 2544-Based Benchmarking Test - Juniper ACX1000 Configuration Manual

ACX Series Universal Access Router Configuration Guide
Table 107: Parameter for test-name configuration (continued)
Parameters
test-profile
vlan-cfi
vlan-id
vlan-priority

Configuring a Test Profile for an RFC 2544-Based Benchmarking Test

1346
Description
Specify the name of the
test-profile
The parameter is ignored when mode
test-profile
NOTE: This parameter is not supported on ACX5048 and ACX5096 routers.
CFI bit used in the VLAN tag.
NOTE: This parameter is not supported on ACX5048 and ACX5096 routers.
Configure the VLAN ID for the test frames.
This parameter is valid only for mode
NOTE: This parameter is not supported on ACX5048 and ACX5096 routers.
Configure the VLAN priority value.
Range: 0 through 7.
NOTE: This parameter is not supported on ACX5048 and ACX5096 routers.
The following topics describe how to configure a
stop a RFC2544-benchmark test, and copy the test result to a local or a remote file.
Configuring a Test Profile for an RFC 2544-Based Benchmarking Test on page 1346
Configuring a Test Name for an RFC 2544-Based Benchmarking Test on page 1348
Starting and Stopping the RFC 2544-Based Benchmarking Test on page 1354
Copying an RFC 2544-Based Benchmarking Test Result on page 1354
You can configure a test profile by including the
the [edit services rpm rfc2544-benchmarking]
the parameters for configuring test-profile.
To configure a test profile:
In configuration mode, go to the
1.
[edit]
user@host# edit services
Configure an RPM service instance.
2.
[edit services]
user@host# edit rpm
Configure an RFC 2544-based benchmarking test for the RPM instance.
3.
to be used for the test.
is used.
reflect
.
ethernet-loopback
test-profile
test-profile profile-name
hierarchy level.
[edit services] hierarchy level.
Copyright © 2017, Juniper Networks, Inc.
and a test-name , start and
statement at
Table 106 on page 1341 lists