Juniper ACX1000 Configuration Manual page 1411

Copyright © 2017, Juniper Networks, Inc.
cross-connect (CCC) as the family. If you do not configure the destination IPv4 address,
the default value of 192.168.1.20 is used.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set destination-ipv4-address address
Specify the source MAC address used in generated test frames. This parameter is
9.
effective for a CCC family and it is not applicable for an
parameter for an family, a commit error occurs when you commit the configuration.
inet
This parameter is optional for a CCC family. If you do not configure the destination
MAC address, the default value of 0x00:0x60:0x67:0x71:0xC6:0x62 is used.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set source-mac-address address
Specify the destination MAC address used in generated test frames.
10.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set destination-mac-address address
Specify the logical interface on which the RFC 2544-based benchmarking test is run.
11.
This is a local user-to-network interface (UNI) on behalf of which the test frames are
generated when the test direction is egress.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set test-interface interface-name
Specify the service type as E-LINE or E-LAN.
12.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set service-type eline | elan
Specify the forwarding class to be used for test frames. The forwarding class specifies
13.
the manner in which the test frames are processed by the Packet Forwarding Engine
of the router. If you do not configure this parameter, test frames are treated as
best-effort traffic.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set forwarding-class class-name
Configure the address type family for the benchmarking test. The
14.
that the test is run on an IPv4 service. The
an CCC or Ethernet pseudowire service. The
in Step 7 specifies the direction (ingress or egress) to be used for the test.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set family inet
Specify the EtherType to be used for reflection of the test frames, which is a two-octet
15.
field in an Ethernet frame that defines the protocol encapsulated in the frame payload.
This parameter is valid only if you configured the test mode to be a reflector. If you do
not configure this parameter, all EtherTypes are reflected. Use an EtherType value
Chapter 37: Configuring RFC 2544-Based Benchmarking Tests
inet
ccc option indicates that the test is run on
statement that you configured
direction
family. If you specify this
option indicates
inet
1353