Juniper ACX1000 Configuration Manual page 1348

ACX Series Universal Access Router Configuration Guide
user@PE1> show l2circuit connections
Layer-2 Circuit Connections:
Legend for connection status (St)
EI -- encapsulation invalid
MM -- mtu mismatch
EM -- encapsulation mismatch
CM -- control-word mismatch
VM -- vlan id mismatch
OL -- no outgoing label
NC -- intf encaps not CCC/TCC
BK -- Backup Connection
CB -- rcvd cell-bundle size bad
LD -- local site signaled down
RD -- remote site signaled down
Legend for interface status
Up -- operational
Dn -- down
Neighbor: 192.0.2.3
Interface
ge-2/0/5.0(vc 100)
Remote PE: 192.0.2.3, Negotiated control-word: No
Incoming label: 299840, Outgoing label: 800001
Negotiated PW status TLV: No
Local interface: ge-2/0/5.0, Status: Up, Encapsulation: ETHERNET
Neighbor: 192.0.2.4
Interface
ge-2/0/5.0(vc 100)
user@PE2> show l2circuit connections
Layer-2 Circuit Connections:
Legend for connection status (St)
EI -- encapsulation invalid
MM -- mtu mismatch
EM -- encapsulation mismatch
CM -- control-word mismatch
VM -- vlan id mismatch
OL -- no outgoing label
NC -- intf encaps not CCC/TCC
BK -- Backup Connection
CB -- rcvd cell-bundle size bad
LD -- local site signaled down
RD -- remote site signaled down
Legend for interface status
Up -- operational
Dn -- down
Neighbor: 192.0.2.3
Interface
ge-2/0/6.0(vc 200)
Remote PE: 192.0.2.3, Negotiated control-word: No
1290
On Router PE1 and Router PE2, use the
1.
verify that the Layer 2 circuit to Router PE3 is
PE4 is in standby mode.
The output also shows the assigned label, virtual circuit ID, and the
encapsulation type.
NP -- interface h/w not present
Dn -- down
VC-Dn -- Virtual circuit Down
Up -- operational
CF -- Call admission control failure
IB -- TDM incompatible bitrate
TM -- TDM misconfiguration
ST -- Standby Connection
SP -- Static Pseudowire
RS -- remote site standby
XX -- unknown
Type St Time last up
rmt Up Oct 18 15:55:07 2012
Type St Time last up
rmt ST
NP -- interface h/w not present
Dn -- down
VC-Dn -- Virtual circuit Down
Up -- operational
CF -- Call admission control failure
IB -- TDM incompatible bitrate
TM -- TDM misconfiguration
ST -- Standby Connection
SP -- Static Pseudowire
RS -- remote site standby
XX -- unknown
Type St Time last up
rmt Up Oct 18 15:55:07 2012
show l2circuit connections
and the Layer 2 circuit to Router
Up
# Up trans
1
# Up trans
# Up trans
1
Copyright © 2017, Juniper Networks, Inc.
command to
ETHERNET