Juniper ACX1000 Configuration Manual page 1364

ACX Series Universal Access Router Configuration Guide
Configuration
Step-by-Step
Procedure
1306
To configure a single mesh group to terminate the Layer 2 circuits into an LDP-based
VPLS, perform the following tasks:
Configuring the Spoke PE Routers on page 1306
Configuring the Hub PE Router on page 1308
Verification on page 1309
Configuring the Spoke PE Routers
Configure a single mesh group to terminate all the Layer 2 circuit pseudowires and enable
local switching between the pseudowires.
On Router PE1, configure the Layer 2 circuit by including the
1.
the hierarchy level. Include the
[edit protocols]
IPv4 address of the hub PE router. Also configure the logical interface by including
the statement and specify the interface connected to Router CE1.
interface
Configure the virtual circuit ID by including the
specifying as the ID value at the
100
interface ge-1/0/0.0]
Configure the backup neighbor by including the
specifying the IPv4 address of the backup hub PE router. Router PE3 is the backup
neighbor in this example. Also include the
l2circuit neighbor 192.0.2.5 interface ge-1/0/0.0 backup-neighbor 192.0.2.3]
level.
[edit protocols]
l2circuit {
neighbor 192.0.2.5 {
interface ge-1/0/0.0 {
virtual-circuit-id 100;
backup-neighbor 192.0.2.3 {
standby;
}
}
}
}
On Router PE2, configure the Layer 2 circuit by including the
2.
the [edit protocols] hierarchy level. Include the
IPv4 address of the hub PE router. Configure the logical interface by including the
statement and specifying the interface connected to Router CE2.
interface
Configure the virtual circuit ID by including the
specifying 100 as the ID value at the
interface ge-1/0/2.0]
specify as the type.
ethernet
neighbor
virtual-circuit-id
[edit protocols l2circuit neighbor 192.0.2.5
hierarchy level.
standby
neighbor
virtual-circuit-id
[edit protocols l2circuit neighbor 192.0.2.5
hierarchy level. Include the
l2circuit statement at
statement and specify the
statement and
statement and
backup-neighbor
statement at the
[edit protocols
hierarchy
statement at
l2circuit
statement and specify the
statement and
statement and
encapsulation
Copyright © 2017, Juniper Networks, Inc.