Vci - Juniper ACX1000 Configuration Manual

vci

Syntax
Hierarchy Level
Release Information
Description
Options
Required Privilege
Level
Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
vci vpi-identifier.vci-identifier;
[edit interfaces at-fpc/pic/port unit logical-unit-number],
[edit interfaces at-fpc/pic/port unit logical-unit-number family family address address
multipoint-destination address],
[edit logical-systems logical-system-name interfaces at-fpc/pic/port unit logical-unit-number],
[edit logical-systems logical-system-name interfaces at-fpc/pic/port unit logical-unit-number
family family address address multipoint-destination address]
Statement introduced before Junos OS Release 7.4.
Statement introduced in Junos OS Release 11.1 for the QFX Series.
Statement introduced in Junos OS Release 12.2 for the ACX Series Universal Access
routers.
For ATM point-to-point logical interfaces only, configure the virtual circuit identifier (VCI)
and virtual path identifier (VPI).
To configure a VPI for a point-to-multipoint interface, specify the VPI in the
multipoint-destination statement.
VCIs 0 through 31 are reserved for specific ATM values designated by the ATM Forum.
—ATM virtual circuit identifier. Unless you configure the interface to use
vci-identifier
promiscuous mode, this value cannot exceed the highest-numbered VC configured
for the interface with the
Range: 0 through 4089 or 0 through 65,535 with promiscuous mode, with VCIs
0 through 31 reserved.
vpi-identifier —ATM virtual path identifier.
Range: 0 through 255
Default: 0
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
Configuring a Point-to-Point ATM1 or ATM2 IQ Connection
Applying Scheduler Maps to Logical ATM Interfaces
multipoint-destination
promiscuous-mode on page 1682
vpi (ATM CCC Cell-Relay Promiscuous Mode) on page 1776
maximum-vcs option of the
Chapter 41: Configuration Statements
vpi statement.
1773