Juniper ACX1000 Configuration Manual page 1578

ACX Series Universal Access Router Configuration Guide
Required Privilege
Level
Related
Documentation
1520
—(M120, M320, MX Series, and T Series routers only) The EXP bit of the
no-label-1-exp
first label is not used in the hash calculation to avoid reordering complications.
payload —Incorporate bits from the IP payload into the hash key for per-flow load
balancing Layer 2 information based on MPLS labels.
—(PTX Series Packet Transport Routers only) Exclude IP payload from the
disable
hash key.
ether-pseudowire —(M120, M320, MX Series, and T Series routers only) Load-balance
IPv4 traffic over Layer 2 Ethernet pseudowires.
—(M Series, MX Series, and PTX Series) Precedes Ethernet packet
zero-control-word
to indicate the start of an Ethernet frame in an MPLS ether-pseudowire payload.
ip —Include the IP address of the IPv4 or IPv6 payload into the hash key for per-flow
load balancing Layer 2 information based on MPLS labels. For the PTX Series Packet
Transport Routers, this is the default setting with both Layer 3 and Layer 4 IP
information included in the hash key.
—(PTX Series Packet Transport Routers only) Exclude IP payload from the
disable
hash key.
—Include only Layer 3 IP information from the IP payload data into the
layer-3-only
hash key for per-flow load balancing Layer 2 information based on MPLS labels.
port-data —(M120, M320, MX Series, and T Series routers only) Include the source
and destination port field information into the hash key. By default, the most
significant byte and least significant byte of the source and destination port fields
are hashed. To select specific bytes to be hashed, include one or more of the
,
source-msb source-lsb
forwarding-options hash-key family mpls payload ip port-data]
prevent all four bytes from being hashed, include the
the
[edit forwarding-options hash-key family mpls payload ip]
—Include the least-significant byte of the destination port.
destination-lsb
destination-msb —Include the most-significant byte of the destination port.
—Include the least-significant byte of the source port.
source-lsb
source-msb —Include the most-significant byte of the source port.
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
Configuring Load Balancing Based on MPLS Labels
Configuring Load Balancing for Ethernet Pseudowires on page 797
, , and
destination-msb destination-lsb
Copyright © 2017, Juniper Networks, Inc.
options at the
[edit
hierarchy level. To
statement at
layer-3-only
hierarchy level.